So this is the pad when I chose your sampler mapping that you send me.
this is after pushing some buttons. colors changed but nothing happened to playing songs or flashing or colors
this is just after pushing more buttons
this is the sampler mapping. row 1 pad 1 is the top left corner button
this is the mapping I did. row 1 pad 1 I chose sampler pad 1 . That way when I hit that button, the jingle I placed on there plays. I was just missing the fade and the color coding.
those are the jingles I put on the buttons. the sample pad numbering goes from left to right and then into the next row and so on.
Basically sample pad 1 is top left, top right is sample pad 8.
Second row left is sample pad 9 and so on .
I hope it makes sense
Basically sample pad 1 is top left, top right is sample pad 8.
Second row left is sample pad 9 and so on .
I hope it makes sense
I made a litte sheet. Maybe You can really figure it out for me ;)
If you could program a mapping for me with the following already set:
The sample pad buttons are programmed to the correct row and pad.
Buttons are programmed to the color in the sheet below
blinking when playing
all programed for fade out at 5 seconds. The 10 seconds was too long
If you could program a mapping for me with the following already set:
The sample pad buttons are programmed to the correct row and pad.
Buttons are programmed to the color in the sheet below
blinking when playing
all programed for fade out at 5 seconds. The 10 seconds was too long